According to my personal understanding, any micro-holes, narrow slits, thin plates that are easy to cut and deform, and even EDM electrodes are suitable for wire cutting.

In addition, the surface roughness of the parts after processing can reach 1.25~2um, so it is also suitable for the processing of precision parts!

Engaged in CNC turning and milling, sometimes there are no more than four knives on the tool holder, and it is necessary to cut the blade;

When processing eccentric parts, it is necessary to use wire cutting to process gaskets of different thicknesses;

Sometimes when processing thin-walled parts, it is necessary to design a thin-walled sleeve. In the design of the fixture, it is necessary to design a spring-up sleeve, etc., which need to be processed by wire cutting!

In addition, wire cutting is relatively simple, can be processed using G code and computer graphics, as long as it is conductive, no matter how hard. It is possible that the individual does not have to process more complicated parts when using it, draw a good picture, and do not need to set the knife. It is almost enough to adjust the relative position of the molybdenum wire and the sheet material. It can be used, and no coordinates are used. The department said that anyway, the maps are all painted, they can be processed directly, and then you can not ask, you can go directly to the workpiece to get the time, it is cool, do not need to look at the side like car milling!